Thread: Settings for AnyCubic Photon
View Single Post
  #4  
Old May 10th, 2022, 11:26 PM
S1R_ART0R1US's Avatar
S1R_ART0R1US S1R_ART0R1US is offline
Under Taro's Banner
  
Join Date: October 15, 2007
Location: Santa Barbara, CA
Posts: 2,468
Images: 32
Blog Entries: 1
S1R_ART0R1US is inducted into the Halls of Valhalla S1R_ART0R1US is inducted into the Halls of Valhalla S1R_ART0R1US is inducted into the Halls of Valhalla S1R_ART0R1US is inducted into the Halls of Valhalla S1R_ART0R1US is inducted into the Halls of Valhalla S1R_ART0R1US is inducted into the Halls of Valhalla S1R_ART0R1US is inducted into the Halls of Valhalla S1R_ART0R1US is inducted into the Halls of Valhalla
Re: Settings for AnyCubic Photon
I do not have a printer, but have learned some tips as I researched getting one for Heroscape prints.
1) Level the bed. May need to repeat this.
2) Glue stick on your bed can be useful if you have problems getting prints to stick (FDM not resin)
3) A rinse basket to dunk into a container of IPA is useful
4) Make sure both the printer and the above have adequate ventilation, and consider using a P100 respirator
Last edited by S1R_ART0R1US; May 13th, 2022 at 01:49 AM. Reason: caveat on 2
Reply With Quote