ATTENTION:
SNEAK PEEK - A Unique Hero in development for C3V Wave 15.5!
(Large Figure - peanut based)
RACHEIM - Released!
The figure used for this unit is a Bonechill Chimera figure from the Dungeons & Dragons Dangerous Delves set. Its model number and name is Bonechill Chimera #10.
IMPORTANT: This is the first C3V figure that will not be ready out of the box. The wings of the original figure cause placement problems, so we have developed a quick and easy mod to correct the issue.
Chimera Mod:
Spoiler Alert!
OK Boil and dip method took less than 5 minutes after I got the water boiling.
Prep:
Tools of the Trade:
1 Binder Clip
Wax Paper
Big Spoon/Ladle
Pot Holder
Boiling Water
Big Pot
Step 1: Boil Water (about 10-15 minutes)
Step 2: Dip (60 seconds)
Step 3: Take out of Water
Step 4: Grab and pinch wings together at front elbows.
Step 5: Cover with small piece of wax paper and clip with binder clip.
Step 6: Place in Freezer and freeze for 1 min.
Step 7: Remove from Freezer and remove clip and wax paper.
Results:
Spoiler Alert!
Fits in a 1-hex hole:
Done.
Here is the Chimera about 1 week later. As you can see it still fits in a 2-hex hole and the wings have stayed relatively in position.
4 weeks later Mod still holds:
2 months later and counting. Mod holds: