August 7th, 2020, 07:56 PM
|
|
Frank Lloyd Wright of Scape
|
|
Join Date: June 29, 2017
Location: USA - UT - Saratoga Springs
Posts: 1,130
|
|
Re: Digital Kitbashing 3d Printing with Original HS figure s
Quote:
Originally Posted by TREX
Quote:
Originally Posted by Flash_19
Quote:
Originally Posted by TREX
Quote:
Originally Posted by Flash_19
|
Haha. Pretty much can do just about anything with kitbashing with the endless amount of content on the web. I havent been able to model anything this week but I may have a little time to play with some of these ideas for sure. I also need to get the resin printer going again. I just finished a set of prints that took 36 hours to make my mom a sweet lawn gnome. Its almost a foot tall. Not bad for my little printbed. I sliced him up into 5 pieces.
|
You 3D printed a lawn gnome?!?
That's pretty awesome.
EDIT: I got my filament today! Now I just need the time to get it all set up!
|
Ive 3d printed 8 lawn gnomes. This one is just way bigger than the rest.
|
Even better!
|