|
|
|||||||
| Software Software created for enhancing HeroScape |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#27
September 7th, 2023, 05:23 PM
|
||||
|
||||
|
Re: X Minus 2 Customs Card Printer
Was cutting out cards just now, and noticed that unfortunately the basic side for Azurite Warlord comes out significantly smaller than all the other cards. Probably should have noticed, looking at a spare printout and it's pretty visible (guess that shows how thoroughly I checked before printing lol)
Uncertified Grammar Comrade
Admin of the Custom BIONICLE Wiki Official Nerdy Fanon Writer Mediocre Heroscaper  
|
|
|||||||
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| BrandonD's 2/19/13 Tradelist - SoTM mint, minus terrain | BrandonD | Sales and Trades | 5 | February 21st, 2013 09:34 PM |
| SOV Nominations - printer friendly PDF | P_J_Keller | Custom Units & Army Cards | 3 | May 31st, 2012 10:44 PM |
| my printer hates my compter and my computer hates my printer | ultradoug | General | 8 | July 17th, 2006 05:57 PM |
Threaded Mode