Index of 3D Printed Terrain Stl Files

[White Knight]

Originally Posted by Guillermo-Tell

Hi,
am I the only one who can't interlock the printed terrain? Looks like the tolerances are really tight.

Also, has anyone tried to print a 24 hex tile? It's huge, impossible to fit in my Ender 3.

Thanks.

I know that my older printer isn't tuned right and doesn't make good interlocking terrain. It tends to print outer edges larger and holes smaller (basically added to much material).

My Ender 3 prints well--the hexes are a little loose, but they interlock.

[robbdaman]

We're gonna need a bigger 3D printer.

Maybe printed sideways it might fit but you'll need a lot of supports.

[Big Oldprankster]

I was pretty happy with the way the interlocking was on the 5 hex bridge piece and the sides. A tad tight with real HS pieces but fit nicely with other printed pieces. I have good luck by slowing the speed to 85% of the basic Cura profile when doing anything with the interlocking edges on my Ender 3 pro.

[Tornado]

Great tip! Thanks.

[Jak]

is there a file for heroscape bases, so I can re base custom figs?

[robbdaman]

Originally Posted by Jak

is there a file for heroscape bases, so I can re base custom figs?

You'll find those on the figure thread.

https://www.heroscapers.com/communit...ad.php?t=54977

[Jak]

thanx!

[Herofly]

You can find Heroscape base files on Thingiverse easily enough.

[mac122]

I think someone accidentally gave positive rep to this bot. My neg rep couldn't flag it.

[White Knight]

TOWER TEST PIECES

So I've been working on the tower pieces for a while.
Could somebody try these and give me your opinion?
The locking tabs seem to work well with the road hexes but not as well with other tower pieces.


DETLETED
(see Thingiverse for Tower pieces)


Any pictures and suggestions would help.

[Guillermo-Tell]

Originally Posted by White Knight

TOWER TEST PIECES

So I've been working on the tower pieces for a while.
Could somebody try these and give me your opinion?
The locking tabs seem to work well with the road hexes but not as well with other tower pieces.

Tower End
Tower End Base

Any pictures and suggestions would help.

Mmm, well, I've had a look at them and here are my two cents:

About the tower end, it's hollow so, I'm not sure about being able to print it without supports inside it as each side is partially or totally closed.

In both cases the top hex hole leads to a wider chamber (not sure how to call it) so, the same case as above.

Thanks for all your effort WK!

[White Knight]

Originally Posted by Guillermo-Tell

Mmm, well, I've had a look at them and here are my two cents:

About the tower end, it's hollow so, I'm not sure about being able to print it without supports inside it as each side is partially or totally closed.

In both cases the top hex hole leads to a wider chamber (not sure how to call it) so, the same case as above.

Thanks for all your effort WK!

On my Ender 3 FDM printer I printed the Tower without supports and the base with supports.

Everything printed well. The only issue was with the tabs on the base ends not flexing enough and breaking, and the internal tabs at the bottom of the tower breaking off. The base end tabs would probably be stronger if I printed the pieces on their sides (so that tabs would not break at the later lines).