C3V/SoV 3D Printable Proxies

[Dad_Scaper]

Originally Posted by White Knight

Ebon Armor 3D scan

Ebon Armor

[Dad_Scaper]

Also, this thread is now stickied.

[White Knight]

Sorry everyone, it's a Skull Demon, not Ebon Armor....

[Dad_Scaper]

Originally Posted by White Knight

Sorry everyone, it's a Skull Demon, not Ebon Armor....

I wasn't going to say that, but I did wonder. It's still great.

[robbdaman]

Added a Grigor and Rogirg proxy and Havech Eradicator proxies.

[robbdaman]

Added Acolytes of Vorganund Proxies.

[Sgt.Erock]

Quahon and Ebon Armor Proxies add to thingiverse

[Pumpkin_King]

Thanks guys! They look great. I like the look of the Quahon proxy. She looks pissed.

[robbdaman]

Added a Mok proxy to my list.

[Flash_19]

Originally Posted by robbdaman

Added a Mok proxy to my list.

Thanks for your work to get these models put up!

Though, I actually have tried to print a couple of the files and they haven't worked for me - when I load the files into Cura, it says "your model is not manifold. The highlighted areas indicate either missing or extraneous surfaces." I am very new to 3D printing and don't understand what the problem is... was the file made to be used with a different slicer? Or would you know how to fix it in Cura?

[robbdaman]

Originally Posted by Flash_19

Thanks for your work to get these models put up!

Though, I actually have tried to print a couple of the files and they haven't worked for me - when I load the files into Cura, it says "your model is not manifold. The highlighted areas indicate either missing or extraneous surfaces." I am very new to 3D printing and don't understand what the problem is... was the file made to be used with a different slicer? Or would you know how to fix it in Cura?

It's likely due to fixes to the model where there were holes. Older versions of Cura don't typically have the error. As many of these are kitbash from a variety of other models they are not perfect but any holes should be covered by other pieces of the model.

[TREX]

Originally Posted by Flash_19

Thanks for your work to get these models put up!

Though, I actually have tried to print a couple of the files and they haven't worked for me - when I load the files into Cura, it says "your model is not manifold. The highlighted areas indicate either missing or extraneous surfaces." I am very new to 3D printing and don't understand what the problem is... was the file made to be used with a different slicer? Or would you know how to fix it in Cura?

What Ive noticed with printing on my two types of printers is that if the model has holes or imperfections my fdm printer has problems with it whereas my resin printer usually does fine. It would have to be repaired most likely. There as a handful of programs that do that.