May 29th, 2019, 02:19 PM
|
|
|
|
Join Date: February 7, 2018
Location: USA - mi- Ann Arbor
Posts: 142
|
|
Re: C3V/SoV Question Dump
Quote:
Originally Posted by superfrog
A couple suggestions/clarifications:
It's yodajunkie who sells bases, not yodaking. Many people have made that mistake, though, so don't feel bad. His are resin cast rather than 3d printed (basically he pours resin into a mold and then pops out the bases when it's dry).
The other person who sells bases is White Knight, and his are 3d printed. This means they have an open bottom like regular official bases, and they're a little bit lighter (weight-wise).
I just tested both of their bases, and neither fits in ladders, but they're close. I think you should be able to sand down either of their bases with a fine sandpaper until you reach the required thickness.
Or, you could mention you had that issue before you place an order, and ask if you could get some that were a bit thinner.
|
Thanks
@ superfrog
! I never thought about just sanding them down a little. That should do the trick.
|