@
TREX
thanks for the tip, I didn’t realize you could rotate for the print, just assumed it was vertical. I’ll keep that in mind.
@
White Knight
I had my heat up a little more than usual, but it was stringing so I had it retracting. I think the retraction was too much and the back and forth cut the filament. So I put the heat back to 200 and turned retraction off. It finished, but here’s the result. I saw a setting where the printer stops extruding before it travels and uses the oozing overextrusion that would normally be the string. I want to try turning that on, turn the temp back up to 205 or 210, and see if that helps with the stringing. Retraction broke the filament and turning down the extrusion left tiny gaps, so that setting is my next attempt. We’ll see. Thanks for the tips!