Quote:
Originally Posted by Tornado
What profile do you use shaolin?
|
A custom one. I use matterhackers soft pla, too many breaks and crazy glue with regular pla. So my temp is a bit higher, 230 C, and print speed is 25mm/s. So the prints do take a few hours to finish. Also I don’t have retraction on, it causes clogging problems when you use softer material. And I use tree supports rather than the default support, I find I can clean it much easier. I’m on my phone now but can send you my profile with suggested tweaks for regular pla. You’re gonna have to tweak it as you print anyway. Use someone’s profile as a base but you’ll need to adjust based on your machine and material. A sturdy build and a level bed are the most important things though, you can clean up anything else after the print, hide imperfections with paint.