View Single Post
  #77  
Old September 11th, 2018, 08:45 AM
shaolin shaolin is offline
 
Join Date: July 27, 2018
Location: USA - MA - Worcester (Auburn)
Posts: 142
shaolin knows what's in an order marker shaolin knows what's in an order marker shaolin knows what's in an order marker
Re: Index of Classic Heroscape .stl files

@TREX thanks for the tip, I didnít realize you could rotate for the print, just assumed it was vertical. Iíll keep that in mind.

@White Knight I had my heat up a little more than usual, but it was stringing so I had it retracting. I think the retraction was too much and the back and forth cut the filament. So I put the heat back to 200 and turned retraction off. It finished, but hereís the result. I saw a setting where the printer stops extruding before it travels and uses the oozing overextrusion that would normally be the string. I want to try turning that on, turn the temp back up to 205 or 210, and see if that helps with the stringing. Retraction broke the filament and turning down the extrusion left tiny gaps, so that setting is my next attempt. Weíll see. Thanks for the tips!
Reply With Quote