View Single Post
  #233  
Old December 31st, 2018, 11:09 AM
Elstree's Avatar
Elstree Elstree is offline
Doesn't need a special title anymore
 
Join Date: May 9, 2006
Location: USA - MA - Amherst
Posts: 1,256
Images: 79
Elstree wears ripped pants of awesomeness Elstree wears ripped pants of awesomeness Elstree wears ripped pants of awesomeness Elstree wears ripped pants of awesomeness Elstree wears ripped pants of awesomeness Elstree wears ripped pants of awesomeness Elstree wears ripped pants of awesomeness
Re: Index of 3D Printed Stl Files

I haven't printed these specifically, but in general if you print right-side up you'll get better results with the surface texture on the top of the tiles; however, you'll also have a whole mess of supports underneath to remove. Upside-down saves you the supports and plastic, but the surface texture may be uneven.

So it's a trade-off.
Reply With Quote