[MementoMori]

I recently switched from Chitubox's supports to PrusaSlicer's.

My process is as follows:

1. Setup PrusaSlicer, as an SL1 printer (it won't matter what's your printer).
2. Load model in PrusaSlicer.
3. Auto orient mini (repeat as many times as needed until it's oriented without supports in critical parts, like faces).
4. Auto support mini.
5. Export mini with supports.
6. Load supported mini in Chitubox.
7. Fix print file in Photo File Validator.

Repeat steps 2-7 for each mini. Since I've been doing this I've had no problems with my prints.