[Nirek]

Just thought this would be a good place to post about de-basing (not debasing) figures as well.

I know I had trouble getting my Omegacron off it's original Clix base until I read online about freezing the figures. It makes a huge difference if you throw you figure in the freezer for 2-3 minutes, as it weakens the adhesive. Following freezing, it is fairly easy to slide an X-Acto knife between the base of the figure and the bottom of the figure itself. Then you just have to work the knife by wriggling it back and forth a few times, and the figure will pop right off. I was somewhat shocked my first time when Omegacron shot across the room.

-Mike