Quote:
Originally Posted by LilMoochie
I print the terrain tiles upside down- it really limits the amount of supports needed. I successfully printed the single hex tiles upright without supports but it had enough stray filaments that the cleanup didn't save me any time.
The actual lava tiles are right-side up with supports- it's the only way to get the glossy sheen on them. Face-down saves filament but gives you a grainy texture where it touches the buildplate.
|
I use a glass bed and can print the hexes upside down and get a nice glossy sheen. It's a little hard to tell from the picture, but they are super smoothe on the top facing the glass.
