View Single Post
  #3242  
Old April 18th, 2021, 08:49 PM
UtahScott's Avatar
UtahScott UtahScott is offline
 
Join Date: May 13, 2006
Location: UT - SLC (Kearns)
Posts: 1,495
Images: 53
UtahScott is inducted into the Halls of Valhalla UtahScott is inducted into the Halls of Valhalla UtahScott is inducted into the Halls of Valhalla UtahScott is inducted into the Halls of Valhalla UtahScott is inducted into the Halls of Valhalla UtahScott is inducted into the Halls of Valhalla UtahScott is inducted into the Halls of Valhalla UtahScott is inducted into the Halls of Valhalla UtahScott is inducted into the Halls of Valhalla
Re: Suggestions for the C3V

Remember the discussion 18 months ago about an Aquilla Flag Bearer? I mentioned Gifted Vision's "Combat Clips" set, as available pre-painted Flags. Finally took pictures today. There's about a 1/2"-square area for a faction emblem to be placed on both flags, could be mass-printed on waterslide decal paper. The surfaces are wavy enough that using Micro Sol / Solvaset to ease the decal into the surface would be mandatory. It would have to be a Dwarf Flagbearer, 'cause each clip is five levels high from the base of the pole, and only a dwarf is short enough to not get in the way. Any dwarf, just pick some available sculpture...



Encompassed about by mountain waves

Last edited by UtahScott; April 18th, 2021 at 10:32 PM.
Reply With Quote