The Book of Bridge of the Gods

[quozl]

OK, I modified it a bit more. I also used the 2 Marvel warehouse bases on level 2 but subbed in concrete 2-hexers for a good picture.

Can you swap those for the warehouses bases in the PDF?

[A3n]

Originally Posted by quozl

OK, I modified it a bit more. I also used the Marvel warehouse bases on level 2 but subbed in 2 concrete 2-hexers for a good picture.

Can you swap those for the warehouses bases in the PDF?

For you Q, absolutely!

[quozl]

Thanks, mate!

I noticed I wrote that weirdly but all of the concrete 2-hexers on level 2 shouldn't be there. Those are standing in for the warehouse bases.

Again, thanks! How's your summer?

[A3n]

PDF linked in OP.

[davidlhsl]

Excellent! I'll build this tonight. I wonder if the following should be added to the Setup instructions:

Please remove the Marvel ruins. Only the bases are used.

Complete text for copy and paste:

Setup: A Time Bomb glyph should be placed on the top of the bridge and two random equipment glyphs should be placed under the bridge. Please remove the Marvel ruins. Only the bases are used.

Second question: should the glyph positions be indicated on the map build?

[quozl]

Actually, since this is a casual map, we shouldn't specify glyphs. I'll remove those from the setup instructions and add in your note about the Marvel ruins.

[A3n]

Originally Posted by quozl

Actually, since this is a casual map, we shouldn't specify glyphs. I'll remove those from the setup instructions and add in your note about the Marvel ruins.

PDF updated.

[quozl]

Looks fantastic!

[davidlhsl]

Ok, I’ve built the map.

I think the ladder locations on Level 10 would work better on Level 11, because there are no anchors for the ladders on Level 10. You see in the 4th and 5th pictures where the ladders extend.

Another item I ran into is the bridge on Level 12 (entire level) doesn’t lie flat for my pieces. You can see the effects of this on my map in the pictures. This may just be an issue with my pieces. You could test with your own pieces by just connecting the pieces on Level 12 and setting it on a flat table to see if it bends with your pieces. Otherwise, the bridge is very solid. (Edit: How many times can I use the word pieces in a single paragraph?)

Edit: I made a comment on one of the pictures that adding a ladder piece to the curved side might anchor the bridge better. No, it still leaves a gap.

Here are the pictures:

Spoiler Alert!

[quozl]

The version I built was slightly different. Are the two ladder pieces used for support needed? If not, they could extend those two ladders that are a bit short.

[Griffin]

It looks like some of the pillars under the bridge are flat on the table while some are on a hex. That could be upsetting the levelness of the bridge.

[quozl]

Originally Posted by Griffin

It looks like some of the pillars under the bridge are flat on the table while some are on a hex. That could be upsetting the levelness of the bridge.

Looks like the pieces on top of the pillars could be put underneath them.